Commission DLAs

In the map file, Commissioner treats DLAs like fixtures. However, because DLAs can be connected to one or more fixtures and communicate using the DALI protocol, they require DLA Commissioning.

1. Select Commission DLAs from the map menu.
2. Click the Fixtures radio button to select individual DLAs ("fixtures"), or click the Zones or Networks radio button to select a group of DLAs.
3. Click Next.
4. If the DLA is connected to a DLA-CA/FA, it requires a fixture characterization file to properly calibrate itself for the 0-10v fixtures attached to it. Select a Fixture Characterization and click OK (for more details, see 0-10 Volt Characterization).
5. Once programming is complete, click Done.

Note: If available, 3rd party DALI controls are auto-detected during commissioning. You must enter power numbers in watts (low end and high end) for all 3rd party DALI controls. If not known, any power calculations for those fixtures will not be accurate.

Last modified: August 11, 2016 01:52:19 PM